method of cutting and manufacturing

    This site uses cookies. By continuing to browse this site, you are agreeing to our use of cookies. More details

    • method of cutting and manufacturing

      hinge door hinge device, in order to make the wooden door hinge reasonable force, the hinge of the door from the distance between the upper and lower doors should be 1/10 of the door height. Wooden doors on the installation of interior details, please read the following.     wooden door hinge device, in order to make the wooden door hinge reasonable force, the hinge of the door from the
      distance between the upper and lower doors should be 1/10 of the door height (usually 200mm). In order to ensure the door hinge device capable of accurate azimuth, range from the doors and door hinge device on the quantity, whether it is still below the upper hinge hinge are request to the upper frame or the door leaf is down from starting point. The width of the hinge is smaller than the thickness of the
      wooden door, and the long edge of the hinge should be aligned with the opposite side of the door. 1, the door hinge and cohesion, amount of 200mm, and draw the line of position, align with the short side hinge line drawing, the long side and the door opposite alignment hinge, then to draw the contour line as the template hinge hinge slots, with flat chisel out hinge groove. The hinge slot should be deep inside
      roll out rubber porch flooring materials
      used marine carpet in brisbane
      structural deck wood plank